ALITA AL-100 Instruction Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
SAFETY INSTRUCTIONS
Inspect the product while unpacking. Check for any damage to the product and the power cable äs result of
shipment, and make sure all bolts and nuts are tightened properly. If there is any problem with the product äs
shipped, contact the product reseller or ALITA representative at once. Please verify nameplate information; be
sure the product received is what you have ordered. Check for correct voltage and frequency on label.
WARNINGS
Special care should be taken when operating an equipment using electricity. To avoid possible electrical shock
or risk to personal safety, please observe all electrical safety rules and tips. Here are some examples:
Do not operate this pump if it falls into or flood by water.
Do not plug this pump to electrical source when there is water on parts that are not intended to be wet.
Do not use this pump in the vicinity of explosive or flammable materials, liquids or gases.
Do not operate this pump if it has a damaged cord or plug, if it is not working properly, or if it has been
damaged or dropped.
Keep power cable away from heated surfaces.
To prevent any personal injury or damage to the equipment, operate the pump only in fully assembled
state.
CAUTIONS
Read and observe all important markings on the pump.
Close supervision is required when operating the pump in the vicinity of children.
This pump is designed to operate with air only. Do not attempt to operate this pump with corrosive
gases, fluid of any type, airborne particles or solids. Any vapor or oil-based contaminants must be
filtered out.
Do not use the air pump other than to transport or move air. The use of attachments not
recommended or sold by the air pump manufacturer may cause unsafe operating conditions.
The ambient operating temperature for this pump is between 41 °F (5°C) and 104°F (40°C).
Operation of pump in temperature outside of the recommended temperature ränge may result in
malfunction or severely shorten the pump Service life.
Always unplug pump prior to serving or maintenance. Grasp plug to remove cord from electrical
outlet. Do not remove by pulling on power cord.
Do not expose pump to excessive weathering or to high moisture concentration.
Do not lubricate this oil-less pump. No parts on this pump have oil or require oil lubrication.
.
Page view 3
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments